6" Chimney Pipe

This "Tristack" chimney system is from the White Metal company. It is triple wall air insulated chimney pipe tested to either 1700 degrees or 2100 degrees "HT" standards and both are available here. Other Options include: Attic Insulation Shield Pipe Shields Elbows for...

9 Foot T System Chimney pipe Kit includes : 3 24" single wall pipe 1 90 degree elbow 1 pipe end plate 1 Tee fire shield 1 Tee 1 Tee support 3 36" chimney section 1 Flashing 0/12 - 6/12 1 Storm collar 1 Chimney cap Options include: Attic Insulation Shield Pipe Shields 11" Support...

11 in. Ceiling Support for use on low sloping ceilings or any installation where the finished ceiling surface is not yet installed. When the finished ceiling surface (sheetrock, wood or other material) then it should be installed snug up to this box. There is a metal trim kit that is available to...

6" x 11" - ceiling support with 6" ID x 11" deep for ceilings that are Flat to 12/12 Pitch - the box is 14" x 14" square at the base and hangs down into the room at least 2" on all sides. You need to add 2x4 blocking in the ceiling as needed to attach this box on...

6" X 30" Ceiling Support - This is only necessary for very steep interior ceilings where the chimney system must hang this far into the room to maintain an 18" horizontal clearance to the ceiling surface. When in doubt, simply send us an email to info@woodheatstoves.com for help...

6" x 12" Chimney Pipe Section - 6" inside diameter & 9" outside diameter   Options include: Attic Insulation Shield Pipe Shields 11" or deeper support boxes Steep flashing Double Wall interior pipe| Elbows for stovepipe or chimney system Chimney Installation...

6" x 36" Chimney Pipe Section For help in completing your chimney system order you can go to this complete system page "complete system diagram and specifications" and/or use the following information. Options include: Attic Insulation Shield Pipe Shields 11" or deeper...

6" Flashing Flat to 6/12 Pitch 6" Skirt - the flat base of this flashing is 25" x 25". We also offer an identical flashing with a base that is approximately 21" x 21" and is described in our parts listings as having a 4" Skirt.   Options include: Attic Insulation...

Chimney cap for 6" Chimney system. 6" Stainless Cap w/Spark Arrestor fits most types of  6" chimney pipe - it attached by having an extended inner pipe that slides into the chimney pipe For help in completing your chimney system order you can go to this complete system page...

6" Flashing 0 Pitch 4" Skirt for 6" chimney systems