8" x 12" BLACK MATTE Stovepipe
IMPORTANT INSTALLATION NOTE:
All stove pipe should be installed with the crimped end/male end facing down so that liquid creosote will drip into the stove instead of outside of the pipe. All joints should be secured with 3 sheet metal screws at each joint. A slip connector section is almost always needed to adjust the length and get the proper overlap on all joints. Stoves should always be vented thru a chimney system that is the same size diameter as the stove flue. If necessary a larger chimney pipe can be used but the draft/performance will be reduced for the stove. Unless otherwise specified by the stove or pipe manufacturer's listed instructions all single wall stovepipe can be no closer than 18" to a combustible surface measured perpendicular to the pipe. Pipe shields can be added to reduce the clearance to combustibles to 6". A double wall pipe can also be used to reduce these clearances. Reducing pipe clearances is often required to use the reduced stove clearances to walls and conserve space and hearth size. Contact us at email@example.com for more assistance as needed.
Each piece of 12" stovepipe actually gives you 10" of usable pipe due to the overlapping joint.
Make sure to include a slip connector with each set of stovepipe to get vertical adjustment between the stove and the ceiling support box. You will find the slip connector in the same list as you are ordering from or by clicking here.
Contact us by emailing firstname.lastname@example.org if you have any questions after looking thru the text and diagram on the complete chimney system product page at the top of this parts list or by clicking here.
This product was added to our catalog on Monday 26 March, 2007.