90 Degree Adjustable Elbow for 6" Stovepipe

IMPORTANT INSTALLATION NOTES:
All stove pipe should be installed with the crimped end/male end facing down so that liquid creosote will drip into the stove instead of outside of the pipe. All joints should be secured with 3 sheet metal screws at each joint. A slip connector section is almost always needed to adjust the length and get the proper overlap on all joints. Stoves should always be vented thru a chimney system that is the same size diameter as the stove flue. If necessary a larger chimney pipe can be used but the draft/performance will be reduced for the stove. Unless otherwise specified by the stove or pipe manufacturer's listed instructions all single wall stovepipe can be no closer than 18" to a combustible surface measured perpendicular to the pipe. Pipe shields can be added to reduce the clearance to combustibles to 6". A double wall pipe can also be used to reduce these clearances. Reducing pipe clearances is often required to use the reduced stove clearances to walls and conserve space and hearth size. Contact us at info@woodheatstoves.com for more assistance as needed.Chimney Options include:
Attic Insulation Shield
Pipe Shields
11" or deeper support boxes
Steep flashing
Double Wall interior pipe
Elbows for stovepipe or chimney system

Reviewing this complete chimney installation diagram and parts list may be helpful.

If you want help figuring our what parts you need and a specific quote for your system, send an email to us at info@woodheatstoves.com with your pipe size (6" or 8" ID), height from floor to ceiling, ceiling pitch/slope, roof pitch, zip code and height from ceiling to nearest ridge or surface within 10' horizontally. The chimney must rise 2' over the nearest object within 10'. We will send you a quote for this system cost delivered to your home.