Whitfield Control Board_12055902
12155912 is NO LONGER AVAILABLE - THIS Digital Control Board for Whitfield (WP2) Advantage II-T, III, and Plus Pellet Stoves (FS & INS).
WP2 SERIES - 12055912 is no longer available
Part# 12055902 IS AVAILABLE BUT HAS NO CONNECTION FOR THE IGNITER POWER
THE PHOTO SHOWS BOTH UNITS
12055902 IS Compatible with Whitfield Part # 12055912 WHICH NO LONGER AVAILABLE WITH IGNITER CONNECTOR, 12025902, 12155900, and 12155900R
Replacement digital control board for Whitfield (WP2) Advantage II-T, III, and Plus pellet stoves. If you are replacing an older rotary dial model (analog board), you will need to make the following adjustments: Remove current sensing relay. Remove the white and black wires to terminal #6 & #7 and replace them with the wires going to the relay. Instructions available upon request.
OEM Whitfield part number 12055902. Replaces old part numbers 12025902, 12155900, and 12155900R
FACTORY EXPLANATION:
12055912 is the newer board for the Advantage II-T-C with the igniter hook up. We CAN NO LONGER GET THIS FROM MANUFACTURER.
12055902 is the older board for the Advantage II-T WITHOUT IGNITER CONNECTION.
- The latest model of this panel has a different wiring configuration described by factory technical department in photo and description here:
"The white connector by the fuse in your old board (circled in red below) was a 120/230 VAC power select option that was done away with and now is only 120VAC so the plug that would have connected to it (also circled in red) is no longer used.
The red jumper wire gets pulled off when using the yellow thermostat leads. IHP Tech Support"
- If you are replacing an older rotary dial model (analog board), you will need to make the following adjustments: Remove current sensing relay. Remove the white and black wires to terminal #6 & #7 and replace them with the wires going to the relay.
MFG Direct ship:**SPECIAL ORDER-NO RETURNS, CANCELLATIONS, EXCHANGES, OR REFUNDS***